Important Note
In order to use the UART in a terminal on Linux on the lab machines, you have to run the XFCE terminal emulator from the application launcher.
If you use another terminal emulator, like Gnome Terminal, then you might find you are not in the dialout group (check by typing groups) and so you are not given permissions to open /dev/ttyUSB1.
The Zybo boards used in EMBS appear as a USB serial device when connected to a computer. Under Linux this will appear as a device like /dev/ttyUSB1 or /dev/ttyUSB2.
There are a range of programs that you can use to access the serial device - one of the easiest on Linux is screen. To connect to a serial console, enter:
screen /dev/ttyUSB1 115200
This will connect at 115200 baud rate to the serial device /dev/ttyUSB1.
To exit screen, press Ctrl-A, then release Ctrl-A, press k, then answer y.
If screen shows an error when you try to connect saying the serial port is busy, you might have exited it incorrectly in the past so that it is actually still running in the background. To reconnect to a background screen session, use "screen -dr", or kill all your currently running screen sessions with "killall screen". If this does not work, try turning the board off and on again, or rebooting the machine.
If you wish to use a different program, the full serial settings to use are:
| Setting | Value |
|---|---|
| Bits per second (baud) | 115200 |
| Data bits | 8 |
| Parity | None |
| Stop bits | 1 |
| Flow control | None |